ECU-PRO PC-1

Installation Instructions

Start your PC as normal and allow it to fully boot up.

Place the supplied CD into your CD drive.

Connect your PC-1 interface to your PC with the supplied USB lead into a spare USB port.

Your PC should now detect new hardware and you will see something similar to below in the bottom right corner of your screen:

Then you will get the following window appear:

 Select the 'Install from a list specific location (Advanced)' option and click on Next.

Ensure the 'Include this location in the search' box is ticked and click on Browse.

Now browse to your CD rom where the supplied CD is located and click/highlight the USB Driver folder. Then click on OK. Back at the Found New Hardware window click on Next. The computer will now install the drivers.

Once the drivers are installed the above screen will come up. Just click on Finish. You may have to repeat the above operation again to finalise installation of the drivers. Then re-start your PC.

Once your PC has been restarted - you should be ready to use your lead.

To find out what com port your lead is installed on - please see this tutorial

Problems:

If your PC fails to detect the new hardware and prompt driver installation it may be that your PC already has the drivers installed from some previous hardware. In this case you are ready to start using the hardware without driver installation.

If the scan tool software fails to detect the interface, try the following:

- Check that you have the correct com port selected (tutorial here).

- Ensure the baud rate is 38400

- Ensure the USB is plugged in properly

- Try rebooting your PC and start again

If you fail to communicate with the vehicle, check the following:

- vehicle must be 2001+ petrol or 2004+ diesel or is likely not OBD2/EOBD compatible

- Check your ignition is on (engine does not have to be on)

- Check the lead is plugged snugly